We solve problems you didn't even know you had—with questionable methods

Raccoon Engineering Logo small

Location

602 Dumpster Lane, #34
Ankeny, IA 50023

Open Hours

Mon - Fri : 10:00PM - 5:00AM
Sat - Sun : Closed

a
MakerOnline

Kobra X Gantry Lighting

MakerOnline

Add lighting to your project on your Kobra X printer.

Version 2 note. Added a little extra clearance for printhead variations. ~ Thanks Christian

Uses standard 8mm COB and FCOB lighting. Can be powered of the Kobra USB port or any USB wall adapter or computer. You will need a USB cable extension in whatever length you desire to get to your choice of power source. The USB cable routes nicely down the loom on right side. If you are going to run direct off the Kobra USB, there is Amazon link below. Requires four M3 x 30mm fasteners.