Kobra X and Kobra 4 Stray Redirector

Worried about filament strands falling off the back of your build plate near the nozzle wiper and into the Y axis slot? It happens. I just took off my bottom cover recently and was surprised the amount of filament debris in there. We created a small ramp/platform to catch the small extrusions and keep them from dropping inside your printer.

Simple to install and takes about 2 minutes. 'Remove the four screws holding your bed on using a 2mm allen driver. Sit the bed aside and snap the offramp around the left rear mount as show in picture. Install your bedplate again with the four screws. Done